{"subject":"technical_drawing","questions":[{"q":"The instrument used for drawing circles is the","o":["Set square","Protractor","Compass","French curve"],"a":2,"t":"Technical Drawing","d":"Medium"},{"q":"The instrument used for measuring angles is the","o":["Protractor","Scale rule","Divider","Compass"],"a":0,"t":"Technical Drawing","d":"Medium"},{"q":"The common set square angles are","o":["10°, 80°, 90°","20°, 70°, 90°","30°, 60°, 90° and 45°, 45°, 90°","15°, 75°, 90°"],"a":2,"t":"Technical Drawing","d":"Medium"},{"q":"A line made up of long and short dashes alternating is a","o":["Dimension line","Hidden line","Centre line","Outline"],"a":2,"t":"Technical Drawing","d":"Medium"},{"q":"A line made of short dashes shows","o":["Centre of circles","Hidden details","Outlines","Cutting planes"],"a":1,"t":"Technical Drawing","d":"Medium"},{"q":"In first-angle projection the plan is placed","o":["Behind the elevation","Above the elevation","Below the elevation","To the left"],"a":2,"t":"Technical Drawing","d":"Medium"},{"q":"The view from above an object is the","o":["Section","Plan","Front elevation","End elevation"],"a":1,"t":"Technical Drawing","d":"Medium"},{"q":"The view from the front of an object is the","o":["Front elevation","End elevation","Auxiliary","Plan"],"a":0,"t":"Technical Drawing","d":"Medium"},{"q":"A drawing of a cut-through object showing the inside is a","o":["Pictorial","Section","Plan","Detail"],"a":1,"t":"Technical Drawing","d":"Medium"},{"q":"The scale 1:2 means the drawing is","o":["Twice full size","Four times full size","Half full size","Full size"],"a":2,"t":"Technical Drawing","d":"Medium"},{"q":"The H pencil is","o":["Wet","Medium","Soft","Hard"],"a":3,"t":"Technical Drawing","d":"Medium"},{"q":"The B pencil is","o":["Waterproof","Soft","Hard","Medium"],"a":1,"t":"Technical Drawing","d":"Medium"},{"q":"Isometric drawings use angles of","o":["90°","45°","30°","60°"],"a":2,"t":"Technical Drawing","d":"Medium"}]}